Omnia-audio Omnia.ONE User Manual download pdf (Page 11)

Omnia.ONE Multicast / DAB / Studio Pro

Quick-Start Setup

We know that you’re probably in a hurry to begin using your new Omnia.ONE. If you have technical expertise and

previous knowledge of audio processor fundamentals, using this Quick-Start guide will get you up and running as quickly

as possible. Please refer to the full User Manual for additional installation and setup information.

The following illustrations show the location of the various controls and connectors associated with the installation:

Headphone Jack Headphone Level Control Jog Wheel

Main Menu / G/R Metering LCD Display Level Meters

1. Install the Omnia.ONE in the equipment rack using at least two rack screws. If only two screws are used, they MUST

be installed in the bottom holes of the rack ears!

2. Connect the audio inputs that are appropriate for your installation. The Omnia.ONE accepts balanced line-level

analog audio via the XLR connectors, AES/EBU digital via the bottom RJ-45 jack (using the “StudioHub” standard

pinout) or Livewire.

NOTE: Livewire audio I/O is only to be used if you have an existing Axia or other Livewire system. Otherwise, the

Livewire Ethernet jack can be used to remote control the Omnia.ONE via its built-in webpage interface. See

Appendix C in the full User Manual for details.

3. Connect the audio outputs in a manner that is appropriate for your installation. Choices are balanced line-level analog

audio via the XLR connectors, AES/EBU digital via the top RJ-45 jack (using the “StudioHub” standard pinout) or

Livewire. All outputs are active simultaneously.

4. Connect AC power to the unit (there is no power switch!)

5. Navigate to the Input/Output / Meter Select setting and select Input.

6. Navigate to the Input/Output / Input / Input Src setting and select the Analog, AES/EBU or Livewire input as

appropriate for your installation. If your audio source is active, you should now see meter activity on the LED

bargraph meters.

7. While driving the inputs with typical program material at normal operating level, navigate back up to the

Input/Output / Input menu (by highlighting and clicking on the “<-EXIT” option) and adjust the appropriate input

Level control until the peak-reading input bargraph meters are peaking up to at least –15 and up to –12 dBFS or a

little higher.

8. Navigate to the Input/Output / Output menu and adjust the appropriate control so that the output level is correct for

the equipment that follows the Omnia.ONE.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 168 169

No comments

Omnia-audio Omnia.ONE User Manual Page 11